For many botanists, they want to move the plants from one area to another without damaging or completely killing the plants. This has been considered a convenient method as opposed to growing them which takes a lot of time and effort. Relocation of Growing Cycads through using their parent plants has been often used for conservation or commercial reasons.
Firstly, the older leaves of the tree which are often at the bottom are first cut off. This is done so as to make the roots struggle less in transporting nutrients to a large number of leaves while it still needs to recover from the move. Additionally, the directional orientation pf the leaves are marked so as to enable proper placement of the leaf on moving it to a new location.
The investor is required to measure the diameter of the tree caudex. The caudex refers to the tree branch or stem that stores water for future use. The diameter of the caudex is then used to dig out the tree. That is a circular channel of 3-4 times bigger diameter than that of the caudex is dug around the trees. The same 3-4 times bigger diameter is also used in digging downwards to remove the under roots.
If the holes are properly dug, then the process of removing the tree will be easier when pulling it. However, the investors need to be extra cautious when removing the tree so as to avoid damaging the roots as this may lengthen its recovery time. Additionally, the extra weight of plants due to soil on the roots is also removed by hosing.
After pulling out the trees, a close examination of all roots should be carried out. This is done to evaluate the damage to the roots as well as to cut of ragged roots; the ragged roots are mainly attached to the root ball. On cutting them off, fungicide and rooting hormones are applied on the tips to promote their regrowth so as to adapt to the new area as well as avoid further root damage.
The plant is the relocated to a new location using a machine and vehicle either to be plotted or boxed. Extra care during transportation should be done to avoid additional root damage. For those who want to plant the vegetation in a new location, they need to find an area with a sloppy nature. Additionally, the soils need to have a good drainage system. Thus sandy soils are a common choice.
The area is then prepared through digging a 1 and a half bigger hole diameter and deepness than that of the root ball. The plant is then put in place and covered with soil. The directional orientation of leaves should be observed as the tree is being set to reduce strain on it to adapt to the new location. The soil depth should also be noted as it should be similar to that on the plant while in the old location.
On inserting the plant, an earthen bowl is dug around it where water mixed with rooting hormone is added so as to supply the tree for two to three weeks. The first leaves produced are often weaker and smaller, but they get healthier with time. Relocating plants is successful in almost every season but during the fall season is best.
Firstly, the older leaves of the tree which are often at the bottom are first cut off. This is done so as to make the roots struggle less in transporting nutrients to a large number of leaves while it still needs to recover from the move. Additionally, the directional orientation pf the leaves are marked so as to enable proper placement of the leaf on moving it to a new location.
The investor is required to measure the diameter of the tree caudex. The caudex refers to the tree branch or stem that stores water for future use. The diameter of the caudex is then used to dig out the tree. That is a circular channel of 3-4 times bigger diameter than that of the caudex is dug around the trees. The same 3-4 times bigger diameter is also used in digging downwards to remove the under roots.
If the holes are properly dug, then the process of removing the tree will be easier when pulling it. However, the investors need to be extra cautious when removing the tree so as to avoid damaging the roots as this may lengthen its recovery time. Additionally, the extra weight of plants due to soil on the roots is also removed by hosing.
After pulling out the trees, a close examination of all roots should be carried out. This is done to evaluate the damage to the roots as well as to cut of ragged roots; the ragged roots are mainly attached to the root ball. On cutting them off, fungicide and rooting hormones are applied on the tips to promote their regrowth so as to adapt to the new area as well as avoid further root damage.
The plant is the relocated to a new location using a machine and vehicle either to be plotted or boxed. Extra care during transportation should be done to avoid additional root damage. For those who want to plant the vegetation in a new location, they need to find an area with a sloppy nature. Additionally, the soils need to have a good drainage system. Thus sandy soils are a common choice.
The area is then prepared through digging a 1 and a half bigger hole diameter and deepness than that of the root ball. The plant is then put in place and covered with soil. The directional orientation of leaves should be observed as the tree is being set to reduce strain on it to adapt to the new location. The soil depth should also be noted as it should be similar to that on the plant while in the old location.
On inserting the plant, an earthen bowl is dug around it where water mixed with rooting hormone is added so as to supply the tree for two to three weeks. The first leaves produced are often weaker and smaller, but they get healthier with time. Relocating plants is successful in almost every season but during the fall season is best.
About the Author:
When you are looking for information about growing cycads, go to our web pages online here today. More details are available at http://stores.botanicwonders.com/cycads now.
No comments:
Post a Comment